Skraffino

Skraffino is a Portland cement-based micro-topping / overlay that is ideal for horizontal as well as vertical surfaces and also interior and exterior surfaces. It can be applied at a paper-thin thickness. Numerous decorative effects can be achieved through the creative use of a trowel, sponge, roller, or spray unit. It provides a fast solution for integrally coloring and resurfacing an interior or exterior concrete. Also, it is a cost-effective solution for resurfacing new or old concrete, broomed, trowelled, or creating a multilayered weathered fresco finish. Skraffino has been designed to accept powder or liquid pigments, acid stains, or dyes.

Skraffino Advantages

• Superior bond to various types of substrates
• Superior abrasion resistance
• High compressive strength
• Designed to be burnished
• Accepts various coloring systems – acid stains, integral colors or dyes
• Economical and cost-effective
• Excellent freeze-thaw stability

MIXING & INSTALLATION

1. Place Cp1000 into a clean garbage can for easy access. Always activate Skraffino with pure Cp1000.
2. Skraffino liquid levels are adjustable +/- 10%. However, remember to be consistent. We recommend 4.6 liters of Cp1000 to activate 1 pail of Skraffino.
3. Using the liquid measuring bucket (pre-cut to 4.6 liters), dip and fill to the pre-cut level and pour into a clean 6ga mixing bucket.
4. Add integral colors (Colorfast or Aqua Color) if required into a 5ga mixing bucket and spin for 2- 5 seconds.
5. Place 2/3rd of Skraffino powder into the mixing bucket and spin with liquid for 30 seconds using a slow-speed drill and paddle attachment.
6. Place the remaining powder into the bucket and mix thoroughly for 60 seconds to disperse all ingredients to a pourable consistency. The volume of liquid added is very critical, always use the measuring bucket provided and slightly adjust if necessary with +/- small measuring cup
7. Skraffino is usually applied in two thin coats using a magic trowel or steel trowel. Contractors should perfect their finishing techniques to produce the desired surface.
8. The first coat must be applied ultra-thin, do not worry about the scratch marks as these will be covered with the second application. When applying the second coat only pour a small amount out onto the surface, do not waste time and energy moving large amounts of material around.
9. Trowel to achieve the desired look and finish as you go. Keep a wet edge and blend from one area to the next, avoid leaving hard lines.
10. Ensure a random pattern by rotating and varying your troweling action. Gently break up any lines or repeating patterns.
11. When applying multiple coats, allow each coat to dry, and then repeat the application. The drying time between coats depends on the ambient temperature; normally a minimum of two hours or once the surface has an even dried-colored appearance. Mist with a light application of Cp1000 to dampen the surface if a second coat is applied the next day.
12. Curing will depend on the ambient temperature and weather conditions. During the summer months, Skraffino is ready for light foot traffic in 12 hours after the second coat has been sealed. Heavy traf

NOTE: Skraffino can be used over long periods of time, re-temper by adding a small amount of Cp1000 if necessary. However, this could cause a color shift.

Technical Data

Flammability (ASTM E84)
Flame Spread Fuel | 0
Contribution Smoke | 0
Development | 0

Compressive Strength (ASTM C 109)
28 days | 4200psi

Shelf Life | 6 months